Step 1:

• CLEAN YOUR BIKE and HANDS: For best results, you will need to start with a clean bike and hands. Grease, silicone spray and dirt will all cause you problems so a clean bike and hands are essential.

Step 2:

• EMPTY YOUR TANK: Fuel vapor will destroy the stickers so empty your tank and let it air out for 24hrs before applying stickers.

Step 3:

• SURFACE PREPARATION: Remove old graphics. Start at one edge and heat up the old stickers with the hair dryer or heat gun. They don’t need to be hot just warm so that the glue comes off easily with the sticker.

Step 4:

• APPLYING GRAPHICS: Confirm the placement of your decals carefully. When ready peel backing off and place your decal onto the plastic. Working in small sections, use your thumb to apply pressure to the graphic being careful not to get any wrinkles or bubbles. You have to work from the center out. If you get bubbles, carefully peel the section up and try again. Use a safety pin to pop any small air bubbles. Then smooth out the bubble section moving towards the edges of the graphic.