Features:

• Convenient, easy to use dual syringe epoxy.
• No mess,no spilling and dried out tubes
• Permanently bonds a variety of materials in 90 SECONDS.
• No measuring required. Resists water, gasoline and shop solvents.

Directions:

• Protect work surfaces(metal foil works well).bonding surfaces should be clean and dry
• Rough smooth surfaces for better adhesion(using abrasives or sandpaper)
• Remove storage cap located in plunger.point tips away from face and body while opening,point syringe towards mixing tray and snap off tip end to oppen.Use plastic blister or clean carboard to mix on.Do not mix on metal,Dispense equal parts of resin and hardener by pressing down slowly on plunger.Mix thoroughly until uniform color using a wooden stick,plastic knife or other clean non-metal stirrer
• Apply mixed epoxy to both surfaces to be bonded and hold parts together with a clamp,tape or weights.Remove excess epoxy immediately using a paper towel and denatured alcohol,prior to set
• Product set in 90 seconds.Item can be handled in 10 minutes.Full cure in 24 hours.NOTE:For cooler temperatures,setting time may be longer
• To seal syringe,pull back on plunger,wipe tips and place cap firmly on tips (see illustration below)Note:cap will only fit one way on tips
• Store upright with tips up.Cured product withstands:-40° to 140°F(-40° to 60°C)